What Are the Requirements for a Bonded Warehouse

(5) FIFO recordings. In inventory and accounting records, the owner must configure a warehouse layer for each inventory entry represented in each inventory category. Shifts must be determined in the order in which importation is accepted or on the date of importation of the goods covered by each applicable inventory entry. No mixing of stratification takes place in the same warehouse, both after the date of acceptance and after the date of importation. The records of each team shall contain at least the storage registration number, the date of acceptance, the date of importation, the quantity and the unit of measurement. For each submission, you must also specify the type of warehouse return number or other specific recovery event that will count towards the submission, by date and quantity. Any addition or deduction of the inventory category must be accounted for in the corresponding inventory category within 2 working days of the occurrence of the event. All FIFO files and documents must systematically use the same unit of measurement in each inventory category. (c) record all manufacturing operations carried out in the warehouse in sufficient detail to determine whether the manufacturing formula lodged with customs has been complied with and to enable customs to verify the use and disposal of the goods. The application, in which the containers are listed by marks and numbers, may be submitted to the customs office or customs inspector of the place where the container is unloaded or, in the case of goods carried under customs seal, at the installation of the customs carrier designated by the port director.

Often, a company chooses to designate part of an existing facility as a bonded warehouse. The customs service shall ensure that the customs and non-customs areas are sufficiently separated by essential materials that prevent unauthorised personnel from entering the customs area. In the event that you choose to designate part of your facility as a bonded warehouse, the tied part of the facility must be separated from the main facility by partitions that meet the following specifications: In Australia, customs warehouses are used for so-called EEGs – excise and excise equivalents – such as alcohol, tobacco and fuel. Companies wishing to use bonded warehouses must have a licence purchased from the Australian Tax Office. At the time the goods are transported from the warehouse to the final destination, customs duties are incurred, which are payable to the government. Trade in goods must be reported to ensure that the correct duties are calculated. However, if the duties are exported or transferred to another customs area, no duty is payable. If you export your freight from the UK, customs must be paid in the destination country. If you would like more information about the UK bonded warehouse we have at Crane Worldwide Logistics, please contact us. (5) Physical inventory.

The owner must make at least one annual physical inventory of all goods in the warehouse or regular cycle counts of selected categories of goods, so that each category is counted at least once a year, with CBP before the date or date. the data is provided so that CBP staff can observe or participate in the inventory if deemed necessary. If the holder of a Class 2 or 9 warehouse possesses goods which fall within the scope of a warehouse entrance but which are stored in more than one storage facility in accordance with § 144.34 of this Chapter, the facility where the original entry was presented must correspond to the stock levels at all locations with the record balance for such entries with goods in more than one location. The owner shall inform the Port Manager of any discrepancies, record appropriate adjustments in the inventory control and recording system and make the necessary payments and entries to CBP in accordance with point (3)(d) of this Section. Contact your local warehouse experts and check here all the details of the location of bonded warehouses used by companies or individuals involved in the sale of products that impose duties when importing or exporting between countries. (1) The items may be used for transportation and delivery to a customs warehouse in an outside port in accordance with the provisions of section 311 of the Tariff Act of 1930, as amended (19 U.S.C. 1311), only for the purpose of immediate export, with the exception of distilled spirits made in accordance with the provisions of section 311 for transport and delivery to a customs warehouse solely for the purpose of immediate export or in accordance with section 309 (a) the Tariff Act of 1930 in the version currently in force (19 U.S.C. 1309 (a)). To make a withdrawal, a request for revocation must be made (see part 18 of this chapter), as provided for in § 144.36 of this chapter. In accordance with section 144.34(b) of this Chapter, a take-back note must be made, accompanied by a filing on Form CBP 301 containing the terms of the obligation set out in section 113.63 of this Chapter. (a) imported goods intended for use in a customs warehouse shall be entered on customs form 7501 or on an equivalent electronic device in the port where that warehouse is located; This form must be prepared in 5 copies and contains all statistical information in accordance with § 141.61 (e) of this chapter. If the goods have been imported into another port or taken to a warehouse, they may be transported to the port where the manufacturing warehouse is located, with immediate transport without expert advice or removal of storage for transport, as the case may be.

In New Zealand, bonded warehouses are known as Customs Control Zones or CCAs. As in other developed markets, these are used to store products that attract tariffs. (i) General. Except as otherwise provided in subsection (d)(3)(ii) of this Section, any theft or theft or suspected overrun, or any defect or extraordinary damage (equal to one per cent or more of the value of the goods in a list or covered by a unique identifier; or if the missing goods are subject to duties and taxes in excess of $100) shall be immediately brought to the attention of the Port Manager. and confirmed in writing within five working days of the notification by the port manager of the defect, exceedance or damage. An entry for the warehouse must be submitted for all overruns by the person authorized to enter within five working days of the date of discovery. The responsible party must pay applicable duties, taxes and interest on flights and shortages reported to CBP within 20 calendar days of the end of the calendar month in which the defect is discovered. The port manager may authorize the amalgamation of customs duties and taxes applicable in the event of multiple bottlenecks into a single payment; However, the amount applicable to each warehouse receipt must be indicated on the application and must indicate the applicable duties, taxes and interest. The same requirements apply if cumulative thefts, bottlenecks or overruns under a particular entry or unique identifier amount to one per cent or more of the value of the goods, or if the duties and taxes due exceed $100. Once identified, the owner records all deficiencies and exceedances in their inventory control and recording system, whether or not they must be reported to the port manager at that time. The holder shall also record bottlenecks and surpluses in accordance with CBP Form 300 or the annual reconciliation report referred to in points (g) or (h) of this Section.

Duties and taxes applicable to non-exceptional defects or damages that are not payable earlier must be reported and submitted to the Port Manager no later than the date on which the CBP Form 300 Certificate of Preparation is due or the time of the due date of the Certificate of Preparation of the Annual Voting Report; as prescribed in points (g) or (h) of this Section. (d) exit point. The point of exit referred to in point (b) of this Section shall be an area in the immediate vicinity of an effective exit from the customs territory, including the waiting area at the boarding gate in the case of an airport, but only if there is reasonable assurance that the goods free of conditional duty delivered to the waiting area of the gate will be exported out of the customs territory. The point of exit in the case of a land border or duty-free store at a seaport is the point where a departing person has no practical choice but to travel to a foreign country or return to customs territory through a U.S. customs inspection facility. The decision of the port manager as to what constitutes the point of departure or a reasonable guarantee of export in a given situation is final. (d) A list of all goods to be manufactured in the warehouse shall be submitted to the port manager. That list shall contain the specific names under which the goods are to be exported and by which they will be known to trade, as well as the names of all ingredients used in the manufacture of those goods and the quantities of ingredients or materials which are taxable or taxable. .